EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (5719 topics).
5719 topics · 27691 messages
-
Pin state in Reset active for ADAU1442 and ADAU1452
Dear support team, I want to know the state of ALL pins in reset state for ADAU1442 and ADAU1452. Could you tell me about it,please? Best regards, Takepiro Audio Signal Processors adau1452 adau1442 Si
-
A qeustion about "mixing down" a freqency
Hello everybody! I will most probably ask something quite ridiculous, but I just wanted to clarify. I need to mix down, say 50Khz down to 5khz. So what I do now, I multiply 50khz to 45khz, then add a
-
Using the AD193x Component in Sigma Studio
Hi, I have purchased the ADAU1446 Evaluation board and am trying to use the AD193x module to control the clock signals for external ADC's / DAC's. The problem is I am not able to communicate with the
-
About voltage of external regulator at ADAU1452W
Dear support team, I have a question about configuration of power for DVDD at ADAU1452W. Q.Is below configuration of DVDD acceptable? VDDIO = 3.3V External PNP transistor input = 1.8V I explained it i
-
Spectral limiter
Hi, Firstly, I am newbie in the Audio Processing world, sorry in advance if I am wrong in some questions. I need to design a dynamic limiter for audio spectrum, known as spectral limiter at least 1/3
-
Boot time of ADAU1442 in self-boot mode.
Dear support team, I want to know the boot time of ADAU1442 in self-boot mode. 10.667ms(PLL Lock Time) + 10ms(wait) + ?ms(EEPROM read) = ? And I want to know a way to know a timing of end of boot. pin
-
About SRC in ADAU1442
Dear support team, Could you tell me about SRC details below ,please? 1.Lock time of SRC from enabling SRC. 2.Ouput delay time of SRC from enabling SRC. Lock time + Group delay? 3.Behavior of SRC when
-
Using the ADAU1700/1701 DSP for Radio Communications
We are currently working on a multimode radio transceiver and one of the functions we wanted to add was DSP primarily for audio signal processing on SSB receive. This in reality is a low intensity app
-
ADAU1772 Noise Generated within Sigma Studio
Hi Everyone, I have an audio design using the ADAU1772. It seems to be working perfectly well from the hardware point of view as the DSP is biasing an electret microphone and outputting the signal to
-
Compressors and Limiters
I've been using the limiter capability within several different Dynamics processors, along with the separate 'Limiter' block. I'm finding that they do not appear to provide a hard limit, but a soft li
-
Lookup table working logic.
Hello guyz, I am playing with the lookup table, looking at its description etc. it is written, that "This algorithm checks if the index at the input is greater than the maximum index and, if so, index
-
Loading into DSP, processing and playing externally prepared audio samples
Hello everybody! Recently I started a topic on a possibility of loading and playing/processing an external audio sample in SS (adau1701 in my case). Since new questions appeared, I decided to bring al
-
how can i save my program(Adau1781) in ext E2prom
Hello I have a problem to save the program. I've read the document the ADAU178 is No Self-Boot then we must connect microcontroller or E2prom to i2c port. Please tell me, how can I do it? Which E2prom
-
Audio sample playback in sigmaDSPs?
Hello guyz, I just wanted to ask, whether a playback of a pre-loaded in memory short audio samples (several mSeconds) is, or will be planned for implementation? I believe a long while ago I asked that
-
ADAU1701 0,90,180,270deg Phase Shift
Hi Bob/Brett, My customer wants arbitrary phase, in which he can choose from, incremented at 0-90-180-270 deg values based on the ADAU1701 sigma core, implemented as part of a sub woofer system. Is th
-
SigmaStudio on Windows 8
Hi Please advise when Windows 8 is supported by SigmaStudio since Windwos 8 machine is quite popular now in the market? Regards, Satoshi 8 windows sigmastudio
-
Max. ratings on ADCs
Hi, are there any maximum ratings for all ADCs (Audio and Aux) on the ADAU1701? I need to know for the hardware design what maximum and minimum voltages can be applied to the ADCs (also negative value
-
ADAU144x rounding problem
It seems that the DSP is operating in "round to lower" mode when store result from multiplication for future processing. In my setup I have a 2nd order IIR hi-pass filter, setup as f = 130 Hz, q = 1.
-
Damping Resistor(s) for MCLK Distribution
The picture below shows a ADAU1401 eval board sending TDM audio to a ADAU1701 on a re-purposed prototype board. Four twisted pairs run the MCLK, BCLK, LRCLK, and TDM data between the boards. The recei
-
ADAU1452 SPDIF interface
I'm new on EZ. I would like to say hello to everyone. I have one question about SPDIF IN/OUT circuit for ADAU1452. Is RC network for RCA connector (IEC60958-3 consumer) this same like ADAU1442? I can'
-
Bug with One Shot blocks?
Hi, I have a very strange issue with the ADAU1701 (tested it on the EVAL-ADAU1701MINIZ board). I use SigmaStudio (x64) V3.9 Build 2 Rev 1246 (I also tested the V3.10 Beta) on a Win7 64Bit Pro. I've tr
-
Success story for ADAU1772 in ANC headset
Is there any ANC headset using ADAU1772 for the noise reduction released in the market? adau1772 Integrated/Special Purpose A/D Converters Audio CODECs
-
SigmaStudio probe : FIR phase error ? (ADAU1452)
Hello, I m preparing a crossover with FIR filter for ADAU1452 and when simulating the result with the probe, I have good magnitude response, but the phase looks completely out. to design the FIR, I ha
-
how is the function of the i2s digital out
Hi I will connect an salve to the adau1701 in i2s mode. the resolution should be 16 bit. what must i config wiht the sigmastudio? thanks for helping hubijo Audio Signal Processors SigmaDSP Audio Proce
-
ADAU1452 group delay / interface / fifo / usbi
Hello I ve just ordered an ADAU1452 eval board and went into the datasheet. congratulation for the exceptional device. The routing is much more clear and looks easier than in the ADU144x family but I