EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (5719 topics).
5719 topics · 27691 messages
-
adau1701 gpio selected level setting
Hi all, I will select with two gpios (in binary mode) between 4 difference volumes. How can i realize that? i tried with demuxer, but i cant get the binary bit combination... thanks for helping best r
-
Interface Read/Write for ADAU1702
I can't seem to find any documentation that maps the interface read and write blocks onto specific digital audio interfaces. Is this mapping correct? Interface Read/Write Interface 0 = SDIN/OUT 0 Left
-
ADAU1452 evaluation board availability
Hi All, When will the evaluation board be available for the ADAU1452 ? See some mention of it on the web, and also that there is a lower introduction price but cannot find it anywhere to be able to re
-
Input signal protection on ADAU1761/1781
What kind of protections are built in to the analog inputs of the Sigma dsps? Put another way, what kind of precautions should I take to condition incoming signals that may be too hot for the ADCs? Do
-
ADAU1772 - Active Noise Reduction?
Hi Guys, I've had to ditch the use of the ADAU1701 for my application. Too many issues getting it working and also it appears that the latency from the ADC to DAC will be too large for what I need as
-
ADAU1452 evaluation board Manual and Schematic
Please the ADAU1452 evaluation board Manual and Schematic Audio Signal Processors adau1452 SigmaDSP Audio Processors
-
ADAU1761 - Maximising dynamic range of compressor
Hi All I wonder if anyone could give me an idea how to maximise the dynamic range of the ADAU1761? ADC noise is worse when dealing with low level signals that are only exercising the lower LSBs of the
-
Sigma DSP volume control implemented using dither?
Hi, Can anyone advise if the Sigma DSP volume control is implemented using dither and, if so, what type of dither is used? Many thanks SigmaDSP
-
Programming EEPROM without SigmaStudio
Is it possible to program the EEPROM from a command line utility instead of needing SigmaStudio running? This is for a production application where I don't want them to have access to SigmaStudio.
-
ADAU1761 Adaptive filter
Hi All I have been playing with module for a couple of months and I would like to help anyone who starts using it with the results of my tests. The toolbox documentation leaves a few gaps which I will
-
ADAU 1701 Datasheet Lack of clear booting documentation
Subject: Lack of clear documentation Inquiry Description: One of our custers has purchased the EVAL_ADAU_1701_MINIZ board in order to start a new professional sound project for megaphony inside big bu
-
ADAU1761 MIC input single Ended Or Differential?
I am confused a bit about the inputs to the PGA. (Figure 33. Stereo Differential Microphone Configuration) ADAU1761 pdf, shows one side of the MIC grounded at the input of the circuit. Seems that just
-
ADAU1761 Output Dynamic Range and Compressor
Hello , I use the ADAU1761 EVB to test the ADAU1761 audio performance , but I test result is not match data sheet specification , as follow as [ No Filter (RMS) and AVDD=3.3V ] 1) I use ADAU1761 DSP f
-
Sign inversion ADAU 1772
I designed a feedback system around the ADAU1772 and started with the evaluation board using the balanced output jacks. Assuming that the tip of the output jack represents the positive phase, the circ
-
ADAU 1701 Miniz - No audio output?
Hello people. I am working with the 1701 mini for my senior project. I have followed all of the instructions in the guide very closely for the first EQ program shown. However, I can not get any output
-
ADAU4601 SPDIF IN DTS 5.1 AUDIO OUT
ADAU4601 SPDIF IN,DTS 5.1 AUDIO OUT DECODE OK? spdif
-
ADAU4601 SPDIF TO DTS 5.1 AUDIO OUT
ADAU4601 SPDIF IN,DTS 5.1 AUDIO OUT OK? spdif
-
Has the bug in the exponential decay block (constant db/sec) been fixed?
SigmaStudio has a known bug, where the block claiming to be an exponential decay is really a linear decay. There is a clever workaround here: https://ez.analog.com/message/64597#64597 However, this is
-
ADAU1446 - No I2C Comms
I have an ADAU1446 on a board that was working on the last spin of the board, but on this board spin, none of my boards are able to communicate to SigmaStudio through the USBi dongle. I have done two
-
Automatic EQ - Impuls Response
Hi all! I like to test (proof of concept) the Automatic EQ function block (ADAU1701 & Sigma Studio 3.10) and I am looking for someone who has some experience with this block. From Bob I got some helpf
-
Query filename, or project version
Is there a clever way to embed the active filename into my project file, so it can be queried via I2C? This would be helpful to identify software versions and such by an external processor. I could ju
-
ADI Phat-Stereo Issue
Could you tell me if I use ADI Phat-Stereo to recommend how many distance between two speaker ?
-
Performance of ADI's New FullFsNR Block
Recently the SigmaStudio team at ADI produced a prototype block that can reduce background noise in speech signals. Presently it's not built into SigmaStudio, but can be downloaded and installed follo
-
Parameter updates with Microcontroller
Please excuse me if this post sounds a little silly, I am a real newbie and following the procedure to boot up with a microcontroller seems like a daunting task to me. Is a there a way to boot up with
-
EVAL-ADAU1701 MINIZ Writeback Circuit
Hello Brett! I have noticed strange behaviour of the mini board ADAU1701 in which the it doesn't do the writeback sequence everytime I do the RESET or re-power up. I believe the writeback circuit allo