EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (7 topics).
7 topics · 21 messages
Filtered by: #automotive ✕
-
ADAU1467 TDM16 problem
Hello, I'm working on a custom A2B subordinate board. The subordinate transceiver get 16 streams from A2B network and generates a TDM16 towards a ADAU1467 with the input serial port 1 configured like
-
Output delay and other timing specs of ADAU146x audio serial ports (and SPI)
Hi, I'm trying to cross-check the timings of various high-speed signals (SPI and audio TDM) between chips that are interfaced on our board, specifically the ADAU146x, AD2428, and our host SoC (TI AM33
-
SPDIF Fs Support
Dear Team, Can anyone please confirm if the EVAL-AD2428WD1BZ Board's SPDIF supports 192kHz Fs or not . Regards, Zayn Audio Products hardware eval-ad2428wd1bz Automotive Audio Bus (A<sup>2</sup>B®) ad2
-
Sigma studio / ADAU1452 set up & tuning advice
Hello, please bear with me as I am new to Sigma Studio but not new to audio tuning in the sense of evaluating & using proprietary sw tools to improve the audio on the car. I have been handed a Sigma S
-
Unable to access AD2420
I am new to Sigma Studio. I want to use AD2420 with Sigma Studio. I have connected it to my desktop using Ethernet. But, still it is not showing up when I start a new project in Sigma Studio. Please l
-
Request information about ADAU1467
Dera Sir/Madam, I am working to evaluate the use of the Analog Device SigmaDSP ADAU1467 for the new Project that mycompany hasto develop. I am interestingto know if for this kind of componennts are av
-
How do I adjust the output level based on the external noise in the listening environment?
In an automotive audio system, I'd like to adjust the output level based on how much environmental noise (due to wind, engine and traffic noise) is in the system. How do I accomplish this? automotive