EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (2 topics).
2 topics · 10 messages
Filtered by: #probe ✕
-
"Add" Features Does Not Simulate in Sigma Studio
Hi Everyone, I'm using the Stimulus and Probe blocks in simulating the behavior of the ADAU1772. All works fine until I try and split part of the signal with the T Connection 1772 and then after some
-
IIR cascade FIR, incorrect phase response display
Hello. I'm using chip ADAU 1701, fs=48000. Sorry, I am a newbie in filter designing. I would like to design an IIR Notch filter at 1kHz. I used "ScopeIIR" software to get the IIR coefficients. Then, I