EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (5 topics).
5 topics · 20 messages
Filtered by: #v4_2e00_6 ✕
-
external ADC and ADAU1452
I have connected a simple stereo ADC : ADC Analog to Digital Converter WM8782 I2S 24Bit from https://www.audiophonics.fr/en/devices-hifi-audio-adc/adc-analog-to-digital-converter-wm8782-i2s-24bit-192k
-
Why does the dynamic range of digital input become smaller after DSP?
We use the ADAU1452, the digital audio input passes through the ADAU1452 and then the digital output, the dynamic range is 86dB. But the digital audio input skip the ADAU1452 to digital output, the dy
-
Flash Programmer for ADAU1452
Dear Team, I have some questions regarding Flashing a binary into the EEPROM of ADAU1452 REV BZ Board. 1. What should the Sub Address byte be typically? 2. The Start Address starts at 0 and increments
-
Master Control Port and Parameter Update
Dear Team, While I see that Sigma Studio allows SPI Parameter updates via GUI / Capture Window , I actually want to update the same SPI parameters using the master Control Port (via the xml file ) . I
-
Sigma DSP Setting SPDIF_TX_CS Registers
We are manually setting both the LEFT (0xF6A0 to 0xF6AB) and RIGHT (0xF6B0 to 0xF6BB) SPDIF_TX _CS registers directly from the register map. In our case we have SPDIF_TX_ AUXBIT_SOURCE (0xF69F) set to