DC Input Entry (no MIPS) (ADAU1761)
Hi,
I know that this has been discussed before, but there is still a bit a mystery for me.
As I understand it, the DC Input Entry (no MIPS) should cause Sigma Studio to generate code which should write a value to parameter memory, although this value is not used anywhere within the executing code in the ADAU1761. However this could be read back by the external controlling processor via I2C or SPI.
For me this would be useful because I can create a version number or date in Sigma Studio which is available to the external controller.
However, although I can create a DC Input entry on the GUI, after the usual "link-compile-download" followed by "export system files" there is no address or data #defined in *IC_1_PARAM.h or any of the other output files to suggest that the value has been loaded to - or is readable from - parameter memory.
Obviously there are ways round this, but it leaves me feeling like I'm not understanding something...
Thanks in advance,
Alex
Audio Signal Processors
sigmastudio
SigmaDSP Audio Processors
adau1761
Hello Alex,
The DC Entry with no MIPS only exists in SigmaStudio and not in the actual DSP program so do not use that one.
Just place the regular DC cell and then place your revision number into that DC cell then it will actually exist in the DSP memory and can be read.
You do not have to connect the DC cell to anything if you do not want to. I usually place a DC cell connected to a Readback to test the DSP communications when using SigmaStudio but you do not have to do that. Then the DSP will not take the time to read the value and place it into the Readback memory address every sample period.
Dave T
Hi, Dave.
Many thanks. That describes it perfectly.
Best regards,
Alex
Please log in to reply.