Execute from flash
Subscribe
Hello. I need execute my program from flash memory. I use custom board with BF537. BMODE = 00. I had tried place LDR (format binary, 16 bit, boot mode Flash/PROM) in 0x20000000, but my program did not start.
Hi,
Sorry for the delay in response.
1) Is the application working in debug mode?
2) Please try to boot with BMODE=1. Please refer BF537 HRM, "Specific Blackfin Boot Modes" in chapter-19 from below link.
www.analog.com/.../ADSP-BF537_hwr_rev3.4.pdf
3) Are you using CCES or Visual DSP?
Regards,.
Anand Selvaraj
Please log in to reply.