ΣSigmaStudio Ask AI Русский Log in

Adau1701 dac resistor user adjustable

SigmaDSP & SigmaStudio pedrorocha123 Jul 31, 2023 00:00 1 replies Original on forum ↗
Subscribe
pedrorocha123 Question
Jul 31, 2023 00:00

I want to make the resistor switchable but I cannot think to much about the noise impact. My factory setup will use the 2v input but I think mobile phone users will suffer. I don't really want to add opamp or volume control. idears are

Option 1 is best for me a I already have a dipswitch in that area linked to the gpio

1. place a 18k or so resistor normally floating and parrell it with the normal resistor using a dip switch to make the 8k or whatever is needed from the 2 resistors

2. Use 3 way header pin and junper to select a 18k or 8k resistor both feed from the input capacitor

3 scrap this idea totally

I understand the resistor must be close to the ic as possible but I don't know if leaving a resistor floating on the adc will have adverse effect. It's a current dac and technically that resistor floating has no voltage and hence no current.

I putting a jumper will Increase the distance of resistor. Maybe it's worse than trying to parrell in another resistor

Audio Signal Processors

Audio Products

hardware

SigmaDSP Audio Processors

adau1701

DaveThib Reply
Aug 1, 2023 00:00

Hello pedrorocha123,

I smiled at your third idea but it actually might be the best option.

I would make careful measurements of headroom and noise floor with both resistors options to see what the results are like. You might find that keeping the 18k is best and just changing the gain of an amplifier that is driving the ADC input instead. That may be the best way to do it.

A resistor floating would not be a big problem because any noise it picks up will have very little current so it should not be a problem. Yes, it has no voltage but it is picking up signals from the air and so it will have some voltage on it but little power. The source impedance of this voltage noise is really high so the current will be really low.

Having the resistor close would be best.

Dave T