Self-boot stopped working with program update
Thread Summary
The user encountered an issue where the eval board stopped working after updating the program and writing to EEPROM, despite successful self-boot initially. The final answer directs the user to an existing thread for further troubleshooting, specifically to check the status of the self-boot pin. No specific Analog Devices products or model numbers were mentioned.AI Generated Content
Hi there,
I have a bit of problem with the eval board at the moment. I was able to successfully self-boot, but have put together some changes to my file, followed the usual compilation and push process, write to EEPROM which appears to work, but when I remove the header from the DSP board and reenable self boot and hit reset, nothing happens. Why does it no long er work? Is there a way I can connect and interrogate the status of the self boot pin with a basic readback perhaps to make sure the ON position is still ON?! Anyone else had this problem?
Many thanks.
Mark
ADAU1467 Evaluation board
software
sigmaStudio 4.7
adau1467
processors and dsp
Processors and Microcontrollers
self-boot
Show More
This thread is closed to avoid duplication. Here is the original thread for you to follow this query.
Regards,
Harish
Please log in to reply.