ΣSigmaStudio Ask AI Русский Log in

SigmaStudio won't start on Windows 10

SigmaDSP & SigmaStudio KKSL Nov 15, 2017 00:00 3 replies Original on forum ↗
Thread Summary

Thread Summary

The user encountered issues running SigmaDSP v3.15 x64 on Windows 10 due to .Net 3.5 installation problems. The issue was resolved by using the DISM command to install .Net 3.5 offline, rather than through the Windows 10 add/remove features. SigmaDSP now functions as expected on Windows 10.
AI Generated Content
Subscribe
KKSL Question
Nov 15, 2017 00:00

Hello,

I am preparing to migrate to Windows 10 and have it set up as dual boot with Windows 7.

I discovered that .net3.5 needs to be installed separately on Windows 10. On doing so I installed SigmaDSP v3.15 x64, but it won't start.

It is showing the message as captured in the attachment.

Without SigmaDSP I can't/ won't migrate to Win10.

Kindly look into this and advice.

Thanks!!

KKSL Reply
Nov 15, 2017 00:00

No luck with v3.16.1. Same issue repeats. I can run v3.15 and v3.16.1 normally on Win 7 though.

On the side note, I am excited about SSM3525 support in v3.16.1. Can't wait to get my hands on the datasheet.

ADIApproved Reply
Nov 17, 2017 00:00

Hi,

Could you please check in your Control Panel that the .Net 3.5 installed properly?

Thanks,

Venky

KKSL Reply
Nov 20, 2017 00:00

Hello Venkatesan,

Short story: The issue was with .net35 integration. It is now resolved.

Long story:

1. After Win10 clean install, I used the Windows 10 add/remove features to install .net35. It uses the internet. .net was installed and I also got a mark against the feature. I installed sigmastudio. However, the application did not open.

2. After Win10 clean install, I used the dism enable0feature command from cmd prompt to install .net35. This does not use the internet. .net was installed and I also got a mark against the feature. I installed sigmastudio and it functions as expected.

I put in a lot of time over the weekend but finally got it going.

So consider this case as solved and closed.

Thanks for your input!