ΣSigmaStudio Ask AI Русский Log in

ADAU1772 initial push button volume with selfboot

SigmaDSP & SigmaStudio Harjo Oct 11, 2017 00:00 2 replies Original on forum ↗
Subscribe
Harjo Question
Oct 11, 2017 00:00

Hi guys,

It seems the ADAU1772 does not apply the "initial push button volume" when it is running in self-boot mode. Similar behavior has been observed by others (see other ADAU1772 threads). Is this a ADAU1772 specific problem, or is SigmaStudio simply not including this parameter in the generated EEPROM file?

*Update*

I found that adding these commands at the end of the EEPROM file fix the problem:

set PB_VOL_CONV_VAL to default (=None)

set PB_VOL_SET at the desired value

set PB_VOL_CONV_VAL to the converter you want to control

This is as described in the ADAU1772 datasheet, page 101:

Address: 0x003F, Reset: 0x00, Name: PB_VOL_SET

This register must be written before Bits PB_VOL_CONV_VAL are set to something other than the default value.

However, in the 'original' EEPROM file the PB_VOL_SET is actually written before the PB_VOL_CONV_VAL are set. Only difference is that they are written in 1 block, so maybe that works out differently.

Unfortunately this is not a fix for the long term. Modifying the EEPROM (including calculating a new checksum) is not very practical. Can this problem please be addressed in the next SigmaStudio release?

Regards,

Harjo.

adau1772

Integrated/Special Purpose A/D Converters

Audio CODECs

DaveThib Reply
Oct 24, 2017 00:00

Hello Harjo,

We have been making lots of updates to the ADAU1772 DLL in SigmaStudio. Which version of SigmaStudio are you using?

Dave T

Harjo Reply
Nov 2, 2017 00:00

The latest version: 3.15

I have found there is another recent thread describing the same problem: ADAU1772 Volume Control

Please keep us posted on possible fixes.

BR,

Harjo.