ΣSigmaStudio Ask AI Русский Log in

AB in CD out Headroom Issue?

SigmaDSP & SigmaStudio jimwoodElectrojim Aug 15, 2013 00:00 2 replies Original on forum ↗
Subscribe
jimwoodElectrojim Question
Aug 15, 2013 00:00

I'm running Sigma Studio 3.8 and using the ADAU144x part. In working with the AB in CD out Condition module, I've run into what looks like a headroom issue.

I stand/beg to be corrected here, but based on the 5/23 format of stating levels, I think that Sigma should be able to accommodate a level to about 15 with its 28-bit internal architecture. I'm using the ABCD module in the 'greater than' mode to compare A and B levels in the 0.1 to 1 level range, and attempting to switch a DC level of 10. (This is to "hurry along" an integrator during a specific event.)

I have a DC Input Entry source set to 10 going into the C input of the block, and am looking at D with both the Real Time Display and a Readback module. When A goes greater than B, I don't see a 10 coming out. If I scale down the DC to a 1, then everything seems to work. Am I violating something here? This reminds me of smacking against the substrate in a 4066 CMOS switch.

ColemanR Reply
Aug 15, 2013 00:00

Glad you were able to figure this one out! Best of luck with your design.

Best regards,

Coleman

jimwoodElectrojim Reply
Aug 15, 2013 00:00

Well, never mind, this was entirely pilot error. Using Sigma modules in unnatural ways to create flip-flops, etc., this circuit is maddeningly complex. I found the proverbial 'loose wire,' so "...there's no charge for the repair, ma'm, your TV is as good as new."