ΣSigmaStudio Ask AI Русский Log in

bypassing delay block in ADAU1761

SigmaDSP & SigmaStudio chuckwin Jun 12, 2013 00:00 4 replies Original on forum ↗
Subscribe
chuckwin Question
Jun 12, 2013 00:00

Hello,

In my main signal path, I go first into a filter block and then into a signal delay block (cascaded) . At the end of the signal chain, I have a bypass switch that lets the user choose between sending either the processed signal to the output or the unprocessed signal. Trouble is, bypassing only seems to work for the filter block... the delay setting does not seem to be affected.

I presume this is because I am not taking into account how the chip is physically constructed. Is it safe to assume that the only way to accomplish a "bypass" of the delay block is to actually set the delay samples to zero?

Thanks for any help you can offer.

chuckwin

Audio Signal Processors

SigmaDSP Audio Processors

adau1761

ADIApproved Reply
Jun 13, 2013 00:00

Hi chuck:

Would you mind sharing your schematic. This will help all debug your problem.

Thank you

Miguel

KJBob Reply
Jun 13, 2013 00:00

Hi chuckwin,

When SigmaStudio compiles a project, each block gets an independent allotment of processor time (instructions), parameter storage, and data memory. The only connections between blocks is their pins you wire together. Thus, with the mux in the position shown below, both the filter and the delay are bypassed as we would expect. When I tested this project on my ADAU1701 board, switching the mux produced an audible difference in "spaciousness" via headphones.

Interestingly when listening to just the one active channel, I couldn't hear any difference when switching the mux. Apparently the ear isn't very sensitive to this sort of change. Perhaps that explains the effect you're experiencing.

Best regards,

Bob

51467a3130dae324e2bf88236eaa0bac.jpg
51467a3130dae324e2bf88236eaa0bac.jpg
51467a3130dae324e2bf88236eaa0bac.jpg-450x176.jpg
51467a3130dae324e2bf88236eaa0bac.jpg-450x176.jpg
ADIApproved Reply
Jun 13, 2013 00:00

Hi chuckwin,

If you construct the bypass switch like in KJBob's graphic above, using a multiplexer block, then you should be able to measure a different amount of delay in the signal path.

chuckwin Reply
Jun 13, 2013 00:00

Hi guys...

Your block diagram is same as mine. Thanks for the confirmation. Now at least I know it SHOULD work and can look elsewhere for my problem.

thanks

chuck