ΣSigmaStudio Ask AI Русский Log in

Connecting more that one pot to 1701mini board?

SigmaDSP & SigmaStudio Skfir Feb 21, 2013 00:00 2 replies Original on forum ↗
Subscribe
Skfir Question
Feb 21, 2013 00:00

Hi guyz! The idea is the 1701 mini board has a pot which can control the volume or whatever. The idea is I need to control two more things. So is it possible to connect 2 more pots to 1701? Could you please advise me which DSP inputs should I connect them to? Other words, which pins of the 1701 have a capability of doing ADC?

KJBob Reply
Feb 21, 2013 00:00

Hi Skfir,

Comparing the MP pin ADC assignments from the -1701 data sheet

to the MP pin arrangement of the mini eval board

shows that MP8 (ADC3) is already wired to the existing pot, and the other MP pins with ADCs are presently used for the three push-buttons. Thus, you could run wires from 3.3V, ground, and the hot side of each push-button to your external pot(s) to use these inputs for ADCs. You'll also need to remove the buttons (or just don't press them), as well as their pullup resistors. You'll need to select the ADCs in SigmaStudio's register control window for the project that uses the external pots -- and restore the original arrangement when using the buttons in other projects.

Bob

76fff35265537855101e286c03d81050.jpg
76fff35265537855101e286c03d81050.jpg
76fff35265537855101e286c03d81050.jpg-450x308.jpg
76fff35265537855101e286c03d81050.jpg-450x308.jpg
613e68170f8d739d4d36eba5e5a2e810.jpg
613e68170f8d739d4d36eba5e5a2e810.jpg
613e68170f8d739d4d36eba5e5a2e810.jpg-411x372.jpg
613e68170f8d739d4d36eba5e5a2e810.jpg-411x372.jpg
Skfir Reply
Feb 21, 2013 00:00

Thanks heaps!!!