1701 input overload protection?
Hi guyz! Just all of a sudden got this question. I am going to build a microphone pre-amplifier for 1701's analog inputs. So the maximum voltage level is 3.3v. The question is, whether the 1701 has any built-in input overload protection diodes? Just in case I make a mistake and unwittingly "feed" the inputs with 5v? Just do not want to burn anything.
The 1701s inputs are driven by currents, not voltages - an external resistor on each input pin converts the signal voltage into a current. This means that the input voltage is not limited to 3.3V, but the input current must be kept below a maximum value. You set the value of these resistors to suit the signal voltage that you expect to see. If you fear overload, choose a resistor value that limits the input current to its maximum allowed value (see datasheet) when the worst-case overload voltage (perhaps 5V in your case) is applied to the input.
In reality the 1701 probably also has input clamping diodes between the input and +3V3/GND and these, in conjunction with the highish-value series input resistors will protect the 1701 against most fault voltages appearing at the signal input side of the resistor (i.e. the end away from the IC).
Fault voltages applied directly to the input pin of the IC are a different matter and should be avoided completely - unless the source is limited to a very low current, damage is likely.
Hope this helps,
Steve L.
It definitely does! Thank you!
Steve,
Your answer is very helpful. In my application hardware we put external Zener clamping diodes to +3.3V and Gnd -- but as you noted, with the input resistors sufficiently high, nothing else is needed.
Bob
Hi everyone,
Thanks very much for your responses. I agree with the information listed by Steve and Bob.
The ADC current input pins indeed have EOS (electrical overstress) protection diodes internal to the device in case a large voltage spike reaches the pin itself, but these should only be relied upon as a kind of last-resort protection. If the EOS diodes are frequently used to sink large currents, their lifetime will be reduced and they may eventually fail. So, it's important to try to limit the frequency of these events by using sufficiently high input resistors and some TVS (transient voltage suppression) diodes on the supply, as Bob noted.
Oops! In my post above I had referred to Zener diodes, but these are actually ordinary diodes (1N4148 etc) wired to clamp above 3.3 V and below Gnd, We didn't use Zeners.
Bob
Please log in to reply.